Loft Conversions in Barnet: Hipped Roofs, Volume Limits, Stairs

Fix Your House designs and builds loft conversions in Barnet — Chipping Barnet, High Barnet, New Barnet, East Barnet, Whetstone and Totteridge — under one contract, and we model the roof in 3D before anything is opened up. This page is about what is particular to Barnet. The general ground — head height, the four types, Building Regulations — is set out on our loft conversions page.

Which Barnet roofs convert easily, and which are harder?

The 1930s semis and detached houses across East Barnet and Barnet Vale convert most easily, because their roofs are traditional cut roofs and a good many of them are hipped.

  • A cut roof — large rafters running eaves to ridge, an open middle you can walk through — is what you want. The space is already usable and the structure can be adapted rather than replaced.
  • A hipped roof is an opportunity rather than a problem. The sloping side can be built up into a gable wall, which squares off an unusable triangle and gives you a straight ridge to work along. Hip-to-gable with a rear dormer is the standard answer on these streets, and it is the move that turns a marginal loft into a proper room.
  • New Barnet’s Victorian and Edwardian terraces convert too, but to the rear, with a smaller volume allowance and with party wall notices on both sides in a mid-terrace.
  • Post-1960s housing is where the trussed rafter roof appears — a lattice of thin W-shaped timbers you have to climb through. People are often told these cannot be done. They usually can, but the trusses are structural and whatever they were doing has to be replaced, which makes it a larger job rather than an impossible one.

How much volume are you allowed, and why does the previous owner matter?

Forty cubic metres for a terraced house and fifty for anything else — and any enlargement a previous owner already built counts against your allowance.

That limit is national, set by Class B of the permitted development order. What is local is how often it has already been partly used up. A rear dormer put on in the 1990s, a box over a bathroom, an earlier roof alteration — all of it counts, even though you did not build it and it may not appear on anything you were given when you bought.

So the first thing we do on a Barnet survey is establish what is already there against the allowance, before drawing a dormer. A design that quietly exceeds it does not fail at the end. It fails halfway through, as a planning application nobody budgeted time for.

What changes if the house is in a Barnet conservation area?

Permitted development for loft conversions does not apply on Article 2(3) designated land, so the route becomes a planning application from the start.

Barnet has a number of conservation areas, and Monken Hadley and Wood Street are among the ones that come up most often on this kind of work. This is not a refusal in advance. It means two things in practice: the design is developed for an application from the beginning rather than adjusted once it is refused, and what the work looks like from the street carries weight it would not carry three roads away.

An Article 4 direction, or the planning history of your own house, can change the answer again. Confirm your address with the London Borough of Barnet before committing to a design — only the council can tell you where you actually stand.

Where will the stairs land, and what do you lose downstairs?

Usually directly over the existing flight, and where that does not work, out of the small bedroom or the landing.

A fixed staircase is required — a ladder is not acceptable for a habitable room, and that is a fire escape requirement rather than a preference. The flight has to arrive in the loft where there is headroom over it, which because of the slope means near the ridge rather than near the eaves. In a 1930s Barnet semi the new flight normally rises straight over the old one, which is the tidiest outcome and takes the least space.

Where the ridge runs the wrong way for that, the stair comes out of a bedroom or eats a usable part of the landing instead. On a smaller terrace, gaining a loft bedroom while losing a third of the second bedroom is a real outcome, and it is worth settling before the roof opens rather than discovering afterwards.

Where the head height over the stair is tight, Approved Document K includes a relaxation specific to loft conversions in dwellings — 1.9 metres at the centre of the flight reducing to 1.8 metres at the side — and that is often what makes an otherwise impossible stair work.

How do you know what it will be like before you commit?

We model your actual roof geometry rather than showing you a generic illustration, and we do the 3D visualisation and BIM modelling in house.

  • The standing zone, drawn on the plan, so you can see how much of that floor area is real room and how much is storage under the slope.
  • Where the stair arrives, how it feels walking up into the space, and exactly what it takes from the floor below.
  • What size of dormer actually buys usable space, tested against the volume allowance rather than guessed at.
  • Whether the bed, the wardrobes and the door swing fit under a sloping ceiling, which is where most loft rooms disappoint people.
  • The rear elevation as the garden and the neighbours will see it, which is frequently what a planning discussion turns on.

Because the same company draws it and builds it, the model is the information the work is built from rather than a picture handed to someone else to interpret.

What we arrange, and what is not ours to sign off

  • Structural design. The new floor, the beams and the alterations to the roof are calculated by a structural engineer. We arrange it; the calculations are theirs.
  • Building control. Approval comes from a building control body — the London Borough of Barnet or a registered building control approver — who inspect at stages and issue the completion certificate. We work to their requirements and book the inspections.
  • Party wall notices. On a terrace or a semi, seating a beam in the party wall brings the work within the Party Wall etc. Act 1996. We flag it at survey and sequence it early, because the statutory timescales do not compress.
  • Gas and notifiable electrical work — neither is ours. We are not Gas Safe registered, so anything touching a boiler, a flue or gas pipework is carried out by a Gas Safe registered engineer. Fix Your House is not a member of an electrical competent person scheme, so we do not self-certify notifiable electrical work.

How is the work priced and presented?

Free call-out and assessment — you only pay for the work. After the survey you get an itemised written quotation against the agreed design, line by line rather than as one figure.

We do not publish a price for loft conversions. A loft is priced by the roof rather than by the room, and two houses on the same Barnet street, built the same year, can differ by a wide margin because one is hipped and one is not, or because a beam will not go up the stairs, or because an en suite sits a long way from the soil pipe. A figure given before anyone has been up through the hatch is a marketing number. Distance to the stack decides whether the en suite pan can run on gravity or needs a pumped waste, so where the toilet can sit in relation to the waste is settled at survey rather than on site.

Where these rules are actually written down

Most of what decides a Barnet loft is published, free, and worth reading before anyone quotes. The Planning Portal sets out when a loft conversion falls inside permitted development and when it does not, on its loft conversion planning permission page, and GOV.UK covers the wider test in when you need planning permission.

Building regulations are separate from planning, and a loft needs both. Escape from a new top storey is governed by Approved Document B, which is why a conversion brings fire doors and a protected stairway with it. The staircase itself — headroom, pitch, guarding — sits in Approved Document K. Between them they are the commonest reason a loft that looks big enough still will not work as drawn.

And the one most people hear about late: a hip-to-gable or a dormer on a semi or a terrace almost always means building on or into the party wall, which brings the Party Wall etc. Act 1996 into play and a notice to your neighbour before work starts. In Barnet’s inter-war semis and long terraces it applies more often than not, and we tell you at the free first visit whether it applies to your house.

If the house is in a conservation area, permitted development is restricted and the detail matters more. Historic England explains what changes for owners in living in a conservation area, and Barnet Council’s Local Studies and Archives record how each part of the borough was built — usually a good guide to what the roof above you actually is.

Questions Barnet homeowners ask

How do I check whether my Barnet loft is tall enough?

Measure from the top of the existing ceiling joists straight up to the underside of the ridge at the highest point, ignoring the insulation and any boarding. Around 2.2 metres or more and a conversion is usually straightforward; between 2.2 and 2.4 metres you normally have a workable room. Then look at the timbers: an open space with large rafters is a traditional cut roof and converts well, while a lattice of W-shaped timbers is a trussed rafter roof and needs more structural work.

Do I need planning permission for a loft conversion in Barnet?

Often not. Converting the loft of a house is usually permitted development, provided the enlargement, including anything a previous owner already added, stays within 40 cubic metres for a terraced house or 50 cubic metres for any other house, and the other Class B conditions are met. It does not apply to flats or maisonettes, or on Article 2(3) designated land. Confirm your own address with the London Borough of Barnet before committing to a design.

What happens if my house is in a Barnet conservation area?

The route becomes a planning application rather than permitted development, because these rights are removed on designated land. Barnet has several conservation areas, Monken Hadley and Wood Street among them. It does not mean the answer is no. It means the design is developed for a planning application from the beginning, and how the work reads from the street carries more weight than it would elsewhere.

What is hip-to-gable, and why is it so common in Barnet?

A hipped roof slopes on the side as well as the front and back, which leaves a triangle of space too low to use. A hip-to-gable conversion builds that sloping side up into a vertical gable wall, turning the triangle into full-height room and giving a straight ridge to work along. It is common here because so much of East Barnet and Barnet Vale is 1930s semi-detached and detached housing with hipped roofs, and it is usually combined with a rear dormer.

Can I stay in the house while the loft is built?

In most cases yes, and it is the main practical advantage of a loft over other extensions. Access is usually by scaffolding and through the roof, so your kitchen, bathroom and bedrooms keep working through most of the programme. The two stages that come into the house are when the beams go in and when the stair opening is cut through the landing ceiling. If there is a cold tank in the loft it normally has to be removed, which means a change to the hot water system and a period without it.

Do you carry out gas or boiler work as part of a loft conversion?

No. We are not Gas Safe registered and we do not carry out gas or boiler work. Where a conversion affects a boiler, a flue or a gas appliance, that part is carried out by a Gas Safe registered engineer, not by us. Roofing and air conditioning are not services we offer either; alterations to the roof structure are carried out as part of the conversion itself.

Nearby and related

The full service page: loft conversions in North West London. Related: house extensions, BIM and 3D visualisation and interior design and build. In Barnet: building work in Barnet, kitchen renovation, bathroom fitting and carpentry.

Call us

Call 07777 759333 — we answer the phone every day from 8am to 10pm. We are based in Mill Hill, London NW7.

Loft conversions in the north of our area, each with its own local rules: loft conversion in Finchley, where conservation areas change the route to permission, and loft conversion in Stanmore, where five conservation areas carry Article 4 directions.