Water on the Inside of the Windows: Condensation or a Leak?
Water on the room side of the glass in the morning is condensation, and it came out of the air inside your house. It is not a leak, the window is not faulty, and no amount of sealant will change it. A leak behaves differently: it wets the frame, the reveal or the sill, it follows rain rather than cold nights, and it is usually worse on the side of the house the weather comes from.
Is the water on my windows condensation or a leak?
Condensation forms on the inside face of the glass, evenly, overnight, and is worst on the coldest morning of the week. Glass is the coldest surface in a room, so it is where warm moist air gives up its water first, which is exactly why it shows there before it shows anywhere else.
A leak wets the timber or the plaster around the window rather than the middle of the pane, appears within a day or two of driving rain, and dries out in settled weather. If you cannot tell which you have, keep a note for a fortnight of when the water appears. Condensation follows the temperature; a leak follows the forecast.
Why is it worst in the bedrooms and worst in the morning?
Because that is where the moisture and the cold meet. Two adults asleep release a surprising volume of water vapour into a closed room over eight hours, and the heating is off for most of that time, so the room reaches its lowest temperature at the moment the air is holding the most moisture.
The same arithmetic explains the other hot spots. Drying one load of washing on a radiator puts roughly a couple of litres of water into the air. A shower and a morning of cooking add more. Nothing about that is unusual or a sign of a defect; the question is only whether that water leaves the house or condenses inside it.
Why is there black mould in the corners and behind the wardrobe?
Because those surfaces are colder than the rest of the wall and the air barely moves across them. An external corner loses heat in two directions at once, and a wardrobe pushed flat against an outside wall stops the room air ever reaching the plaster behind it.
Mould needs about 80 per cent relative humidity at the surface to grow, not standing water, which is why a wall that feels dry to the hand still goes black in the corner. Pulling furniture 50 mm off an external wall and leaving internal doors open is a real change rather than a token one.
How do I tell condensation from penetrating damp and rising damp?
Each one has a signature you can check without any equipment. Condensation appears on cold surfaces overnight, is worst in winter, and is general rather than localised. Penetrating damp is localised, appears within a day or two of driving rain, and lines up with something outside it: a cracked render panel, failed pointing, a slipped flashing or a gutter overflowing down one spot of wall. Rising damp shows as a tide mark that stops at roughly the same height above the floor all along a wall, with salts crystallising at the edge.
The height is the most useful single test. A patch that stops at a level line about a metre up is not condensation, and it is not something to paint over. A damp-proof course is specialist work and we refer it out rather than pretend otherwise.
Does the extractor in my kitchen or bathroom actually go outside?
Check, because a great many do not. A recirculating cooker hood passes air through a charcoal filter and blows it straight back into the room, so every drop of water produced by cooking stays in the house. Only a hood ducted through a wall or roof removes it.
The rates worth knowing are the ones the building regulations set for intermittent extract: 30 litres per second over a hob, or 60 litres per second elsewhere in a kitchen, 15 litres per second in a bathroom and 6 litres per second in a WC. A fan that runs for thirty seconds after the light goes off has not moved anything like enough air. Getting the ducting right is a decision made when a room is built or refitted, which is why it belongs with the layout of a new kitchen or a bathroom fit-out rather than being bolted on afterwards.
One limit worth stating plainly: we carry out minor non-notifiable electrical work only, so where a fan needs a new circuit or any work at the consumer unit, that has to be done by an electrician registered to sign it off.
Will more insulation or new windows fix it?
Insulation helps and sealing alone makes it worse, and the difference between the two is the whole answer. Insulating a cold wall raises its surface temperature, so the air next to it no longer reaches its dew point and the condensation stops. Replacing windows without trickle vents seals the room tighter without warming anything, so the same moisture simply moves to the next coldest surface.
That is why condensation so often appears on the walls a year after new windows go in, and why people conclude the new windows caused damp. They did not create the water. They removed the route it used to take out of the room.
What this looks like in a North West London home
Victorian and Edwardian terraces in Finchley, Golders Green and Hendon are largely solid nine-inch brick, with no cavity to insulate and internal wall surfaces that sit several degrees colder than the room air all winter. In those houses the mould appears on the external walls and in the corners first, and the glass is only the early warning.
The inter-war semis of Mill Hill, Edgware and Burnt Oak usually do have a cavity, so the walls are warmer and the complaint is more often streaming windows and a bathroom ceiling that never dries. Replacement windows have been fitted to most of them at some point, and whether trickle vents were fitted with them is the thing worth checking first. Where that bathroom is about to be refitted anyway, the extractor outlet is worth settling before the tiles go up, and our page on refitting a bathroom in a Burnt Oak house sets out what we look at before any work starts.
Post-war and converted flats produce the third pattern: a small volume of air, a concrete structure that carries cold to the room surface at the floor and ceiling junctions, and often a single extractor doing the work of two. Where plaster has blown on a wall that has been damp for years, the repair is a plastering job, and our page on blown plaster and lath ceilings in Barnet sets out how that is put right.
How is this kind of work priced?
By the job, once the cause has been established, because improving ventilation, insulating a cold wall and re-plastering a damaged one are three different pieces of work with nothing in common but the symptom. Free call-out and assessment – you only pay for the work. No VAT is added on top.
What decides the figure is which of those three is actually needed, how much of the wall surface is involved, and whether the room can be used while the work is done. Anyone quoting for a damp problem without first saying which of the three causes they think it is has not diagnosed anything.
When to stop and call someone
Stop if the damp patch is wet in dry weather. That is not condensation, and continuing to ventilate and wipe will not change it; it needs the outside of the building looked at, starting with the gutters and the rainwater goods, which is where a surprising share of persistent wall damp begins.
Stop if the worst room is one that was built or converted later, such as a rear extension, a garage conversion or a loft room. Condensation concentrated at the junction between new work and the original wall is usually a cold bridge in the construction rather than a ventilation problem, and that is a question for whoever detailed the extension, not for another dehumidifier.
Stop if the plaster has blown, if the skirting is soft, or if mould returns within weeks of being cleaned off a surface you have already insulated. At that point painting over it is money spent on hiding a fault, and the surface needs taking back and re-plastering once the cause has been dealt with.
Frequently asked questions
Is water on the inside of my windows condensation or a leak?
Condensation. Water that forms on the room side of the glass overnight and is worst on the coldest morning is moisture from inside the house. A leak wets the frame, the reveal or the sill, and it follows rain rather than temperature.
Why does condensation appear in the bedrooms and not the living room?
Because two sleeping adults release moisture into a closed room for eight hours while the heating is off. The bedroom is the coldest occupied room in the house at the time the moisture is highest.
Why is there black mould only in the corners and behind furniture?
Those surfaces are colder than the rest of the wall and the air does not move across them. Mould grows at around 80 per cent relative humidity at the surface, so a wall does not have to feel wet to grow it.
How do I tell condensation from penetrating damp?
Condensation tracks temperature and appears on cold surfaces overnight. Penetrating damp tracks the weather, appears within a day or two of driving rain, and usually lines up with a defect outside such as a cracked render panel or an overflowing gutter.
Does a recirculating cooker hood help with condensation?
No. A recirculating hood filters grease through charcoal and returns the air, and all the water vapour from cooking goes straight back into the room. Only a hood ducted to outside removes the moisture.
Will new windows stop condensation?
Not by themselves, and they can make it worse. Replacing windows without trickle vents seals the room tighter, so the same moisture has nowhere to go and moves to the next coldest surface, which is usually an outside wall.