A Wet Patch on the Front Path in Barnet: Who Pays to Dig It Up
Fix Your House traces water leaks across Barnet — EN5 around Chipping Barnet and High Barnet, and EN4 out towards East Barnet and Cockfosters. Very few of these calls are about a dripping tap. They are about water turning up where it has no business being: a damp strip across a drive that never dries, a patch of front lawn that stays green through a dry August, a meter that keeps turning after everything in the house has been switched off.

Water showing up where it should not be, in Barnet? Call Fix Your House on 07777 759333. Free call-out and assessment — you only pay for the work.
Who supplies the water in Barnet?
Two different companies, and knowing which is which saves an afternoon. The mains water into an EN5 or EN4 address comes from Affinity Water, which describes itself on that page as a clean-water-only supply company. The sewer that carries the used water away belongs to Thames Water. Type an EN5 or EN4 postcode into Affinity’s own checker and it says so in one sentence: supplied by Affinity Water, sewerage supplier Thames Water.
This is not the same answer everywhere we work. Barnet, Finchley, Whetstone, Edgware and Mill Hill all come back as Affinity addresses. Hendon and Golders Green, a few miles down the road, do not. So a Barnet householder and a Hendon householder with the identical problem are ringing two different companies, and being told to ring the wrong one is how a morning disappears.
The practical version: if what is surfacing is clean, cold and does not smell, it is arriving through the supply side. If it is foul, or it only appears when the house is using water, it is going out through the drainage side, and that side has been Thames Water’s since the 2011 transfer of private sewers.
Is a leak between the road and my house my responsibility?
Usually, yes — from the boundary inwards. The split is not at the front door and it is not at the meter. It is at the property boundary.
- The communication pipe runs from the main in the road to the boundary. That is the water company’s.
- The supply pipe runs from the boundary to the house. That belongs to the property, whoever owns it.
- The longer the front garden or the driveway, the more of the total run is the private length. On the Barnet streets where the houses are set well back from the road, that is most of it.
- A shared drive serving two or three houses often has one supply pipe with branches, which is why the bill for a repair on it becomes a conversation between neighbours before it becomes a job.
Where is the stopcock, and what happens if it will not turn?
There are two, and you want to know where both are before you need them. The internal stopcock is normally under the kitchen sink, sometimes in a hall cupboard or under the stairs in the older houses. The outside stop valve sits under a small metal or plastic cover in the footway or the front path, usually close to the boundary.
- The internal one is yours to operate and yours to replace when the gland weeps or the spindle seizes.
- The outside one belongs to the water company. If it will not turn, do not force it with a bar — a snapped outside valve on a live main turns a small job into a road closure. Ring the supplier and let them lift it.
- If the internal stopcock is seized, that is worth fixing on a dry day rather than discovering at midnight. It is a short job and it is the difference between a wet cupboard and a wet ceiling.
The water is clean and it is coming up through the drive. What now?
Shut the internal stopcock and watch what happens. If the flow stops, the leak is inside the house and downstream of that valve. If the flow carries on, the leak is on the buried supply pipe, upstream of the house, and no amount of lifting floorboards indoors will find it.
- Close the internal stopcock, then look at the meter. A meter still turning with everything off is a leak on the supply pipe.
- Note whether the water is warm. Warm water surfacing in winter points at the heating pipework rather than the cold supply.
- Keep an eye on pressure at the kitchen tap. A supply-pipe leak that has been running for months often shows first as a tap that has quietly gone weak.
- Old supply pipes in this part of Barnet are frequently not copper at all. Lead, galvanised steel and early black alkathene all behave differently when they fail, and they are found differently.
EN4 and EN5 are not always the same council
EN5 addresses sit in the London Borough of Barnet. EN4 straddles a boundary — part of it falls inside the London Borough of Enfield, which we confirmed against the Office for National Statistics postcode data rather than assuming it. That is irrelevant to a leak under your own kitchen floor and it matters a great deal the moment a repair needs the public footway opened, because the licence comes from the highway authority and the highway authority is not the same one on both sides of that line. If you are unsure which applies to your address, the GOV.UK council finder settles it in a click.
How we find the leak without opening the whole path
By isolating and testing before digging, in that order. The supply pipe is isolated and pressure-tested, so the first thing established is whether it is holding at all and roughly how fast it is losing. Then the run is listened along above ground to narrow where it is losing it. Only then does anything come up, and what comes up is a section rather than a path.
- Pressure first. A pipe that holds is not the pipe leaking, and ruling it out is as useful as finding it.
- Listening along the run, working from the boundary in towards the house.
- Warm-water leaks under a solid floor are traced by temperature rather than by sound.
- Moisture readings through a wall base, to separate a plumbing leak from ground water and from condensation, which look identical on a photograph and are three different jobs.
When the repair is made, the standard it has to meet is not a matter of opinion. The Water Supply (Water Fittings) Regulations 1999 require that every water fitting is watertight, and regulation 5 sets out which work has to be notified to the water supplier before it starts. That is the test a repair is put back to.
What we do not take on
No. We are not Gas Safe registered and do not carry out gas work. The public sewer and the communication pipe in the road belong to the utilities and we do not open the highway to reach them — on those we tell you which company to ring and what to say. Where a job touches electrics we carry out minor non-notifiable electrical work only. Saying this plainly at the start is quicker for everyone than finding it out at the door.
Questions Barnet callers ask
Who supplies the water in Barnet?
Affinity Water supplies the mains water and Thames Water owns the sewer. Put an EN5 or EN4 postcode into Affinity’s own supply-area checker and it returns both answers on one line: supplied by Affinity Water, sewerage supplier Thames Water. It matters because clean water surfacing on a drive and foul water backing up out of a gully are two different companies’ problems.
Is a leak between the road and my house my responsibility?
Usually yes, from the boundary inwards. The length of pipe under the public footway up to the boundary is the water company’s communication pipe. The length from the boundary to the house is the supply pipe and it belongs to the property. On the older Barnet streets where the houses sit well back behind long front gardens, that private length is most of the run.
Do you have to dig up the front path to find a leak in Barnet?
No. The pipe is isolated and pressure-tested first, and the run is listened along before anything is lifted. The point of that order is to open one short section rather than the whole path. Block paving and a tiled Victorian front path are both a great deal easier to put back when only a metre of it has come up.
My stopcock is off and water is still running. What does that mean?
It means the water is reaching the leak from upstream of the internal stopcock, so the leak is on the buried supply pipe rather than inside the house. That is the single most useful test you can do before anyone arrives, and it changes what we bring to the job.
When is the phone answered?
We answer the phone every day from 8am to 10pm. Answering is not the same as attending: when someone does come out, attendance is typically under an hour, and on a call where water is running the first thing we do on the phone is talk you through shutting it off.
Do you carry out gas work?
No. We are not Gas Safe registered and do not carry out gas work. Tracing and repairing a leak on a water pipe is separate work and we do that.
“They took the time to find where the leak was coming from, explained what needed fixing and got the problem sorted without unnecessary fuss.”
Arman I., Google review (leak repair), October 2026
Nearby and related
If the problem is a leak rather than a burst, start with how we approach leak detection and leak repair. For general plumbing work in the same streets see our plumber page for Barnet, and if water is running right now, the emergency plumber page for Barnet is the one you want. Where the water is going out rather than coming in, see blocked drains in Barnet. Next door in Arkley, where many homes sit on gravel and a leaking supply pipe may not show on the surface, see leak detection in Arkley. Under a solid floor the method changes, and finding a leak under a solid floor in Borehamwood explains why. Leak detection nearby: Hendon, Golders Green and Colindale. Every area we cover is listed on our areas page.
Call us
Ring 07777 759333. We answer the phone every day from 8am to 10pm, attendance is typically under an hour, and the call-out and assessment are free — you only pay for the work. No VAT is added on top.